ControlMaster CM30, CM50 and CMF310
Universal process controllers,
1
/4,
1
/2 DIN and fieldmount 7 Advanced Level
IM/CM/ED–EN Rev. X 71
…Profile Parameters / …Enter Program
Guaranteed Ramp
Guaranteed Soak
Select how the Guaranteed Ramp/Soak feature will be applied to the segment.
None Guaranteed Ramp/Soak is disabled for the segment.
High Guaranteed Ramp/Soak is applied above the setpoint.
Low Guaranteed Ramp/soak applied below the setpoint.
High/Low Guaranteed Ramp/Soak is applied above and below the setpoint.
Note. Displayed only if Guaranteed Ramp/Soak is enabled in the Segment Options
menu – see page 62 for detailed explanation.
Event 1 to 8 Select the state of each of the 8 general purpose events for the duration of the segment.
Note. Displayed only if Event 1 to 8 is enabled in the Segment Options menu.
PV Event Select the condition under which the PV Event will become active for the duration of the
segment.
None The PV Event is disabled for the segment.
High Limit The PV Event is enabled when the Process Variable goes above the PV Event Trip value.
Low Limit The PV Event is enabled when the Process Variable goes below the PV Event Trip value.
Dev High The PV Event is enabled when the Process Variable goes above the Setpoint by more
than the PV Event Trip value.
Dev Low The PV Event is enabled when the Process Variable goes below the Setpoint by more
than the PV Event Trip value.
Dev High/Low The PV Event is enabled when the Process Variable goes above or below the Setpoint
by more than the PV Event Trip value.
Note. Displayed only if PV Event is enabled in the Segment Options menu.
Timed Event Offset The offset time in hh:mm:ss from the start of the segment at which the Timed Event will
be enabled.
Note. Displayed only if Timed Event is enabled in the
Segment Options menu.
Timed Event Length The duration of the Timed Event signal in hh:mm:ss.
Note. Displayed only if Timed Event is enabled in the Segment Options menu.
User Value Select the User Value required for the segment within the range defined by the High/Low
limits configured in the User Value Limits menu.
Note. Displayed only if User Value is enabled in the Segment Options menu.
To Next Page
Loading...
