ABB EQmatic
Commissioning
28 2CDC512090D0202 | QA/S x.yy.1
3.2 Management
The Management menu is used to make the following settings:
• M-Bus and Modbus RTU device configuration
• Metering structure set up
• User administration
• Tariff and unit settings
• Consumer group set up
• Data transfer to higher-level systems
Devices (QA/S 3.xx.1 Energy Analyzer, M-Bus)
The Meter Management menu is used to make all the settings for the detection of M-Bus devices
connected. After the scan, all M-Bus devices detected are listed in a table. This step is absolutely
essential during commissioning to be able to add, configure and manage devices. It is the basis for
assigning devices to the metering structure later on.
To Next Page
Loading...
