ABB EQmatic
Commissioning
QA/S x.yy.1 | 2CDC512090D0202 65
Automatic network configuration (Off/On)
Use this parameter to set the network configuration. The device is supplied from the factory
configured for DHCP.
Off: You must enter the device’s network settings manually.
Caution
It will no longer be possible to access the device if the entry is wrong. A reset will be required in
this case (see description of Reset button).
On: Automatic network configuration is activated. The device’s network settings are assigned
automatically by a DHCP server in the network or by a router with DHCP functionality.
If no automatic assignment of the network settings takes place via DHCP, then a standard
network setting in the auto IP range will be used:
IP address:
169.254.1.0 – 169.254.254.255
Subnet mask:
255.255.0.0
Standard gateway:
0.0.0.0
To Next Page
Loading...
