ABB ETL600 - Page 317

Revision: Language: Page:
ETL600 System Test Report
_ EN B5/B11
HE
Test
No. Test procedure Test point
Permissible
value Units
Test
result
B.9.4 Command
transmission time
Command A
Tx command A
Rx command A
Terminal:
(T22/1) – (T22/2) [ ]
(T…/...) – (T.../…) [ ]
(T22/9) – (T22/10) [ ]
(T…/...) – (T.../…) [ ]
Refer HMI600
Mean value
≤T0
ms
TPE1
________
TPE2
________
Command B
Tx command B
Rx command B
Terminal:
(T22/3) – (T22/4) [ ]
(T…/...) – (T.../…) [ ]
(T22/11) – (T22/12) [ ]
(T…/...) – (T.../…) [ ]
Refer HMI600
Mean value
≤T0
ms
TPE1
________
TPE2
________
Command C
Tx command C
Rx command C
Terminal:
(T22/5) – (T22/6) [ ]
(T…/...) – (T.../…) [ ]
(T22/13) – (T22/14) [ ]
(T…/...) – (T.../…) [ ]
Refer HMI600
Mean value
≤T0
ms
TPE1
________
TPE2
________
Command D
Tx command D
Rx command D
Terminal:
(T22/7) – (T22/8) [ ]
(T…/...) – (T.../…) [ ]
(T22/15) – (T22/16) [ ]
(T…/...) – (T.../…) [ ]
Refer HMI600
Mean value
≤T0
ms
TPE1
________
TPE2
________
B.9.5 Reset counters
Menu: Equipment,
Commissioning and
maintenance,
Eventrecorder, Reset
counter, OK:
HMI600 All counters = 0 [ ]
B.10 Testing of O4LE
B.10.1 Service Phone.
Mark if configured:
N11
[ ]
N22
[ ]
N54
[ ]
Pick up the phones and
talk.
Service phone, at front
panel
Remote service
phone rings,
buzzer drones,
talk is possible
N11
[ ]
N22
[ ]
N54
[ ]
B.10.2 Hot line direct phone
Mark if configured:
N11
[ ]
N22
[ ]
N54
[ ]
Pick up the phone, wait,
pick up remote phone
Direct phone
Remote direct
phone rings until
phone is picked
up.
N11
[ ]
N22
[ ]
N54
[ ]
Measure Output level.
Feed 800 Hz with
configured input level of
remote subscriber (Def.:
0.0 dBm).
Feed into rem. equ. at
terminal, telephony 0a-
0b
Measure at terminal,
telephony 0a-0b
Configured Output
level ±1 dB
(Def.: -7.0 dBm)
dBm
(600 Ω)
N11: ___________
N22: ___________
N54: ___________
© ABB Switzerland Ltd Form 1KHW001493-EN
Rev. A