ABB FPBA-01 PROFIBUS DP - Page 43

Start-up 43
3 =
MAP_ERR_WRO
NG_IDX
Wrong mapping index (e.g. index
of PZD 10) is used when PPO
type 2 is in use
4 = MAP_ERR_IN Parameter number or virtual index
number is not supported for input
mapping
5 =
MAP_ERR_OUT
Parameter number or virtual index
number is not supported for output
mapping
6 =
MAP_ERR_SEND
Internal mapping error
10
…
26
Reserved These parameters are not used by
the adapter module.
N/A
27 FBA par refresh Validates any changed adapter
module configuration parameter
settings. After refreshing, the value
reverts automatically to 0 = Done.
Note: This parameter cannot be
changed while the drive is running.
0 = Done
0 = Done Refreshing done
1 = Refresh Refreshing
28 FBA par table ver Read-only. Displays the parameter
table revision of the fieldbus
adapter module mapping file
stored in the memory of the drive.
In format xyz, where
x = major revision number
y = minor revision number
z = correction number
OR
in format axyz, where
a = major revision number
xy = minor revision number
z = correction number or letter.
OR
in format axyz, where
ax = major table revision number
yz = minor table revision number.
N/A
No. Name/Value Description Default