ABB HT611036 - Fig. 111: Fitting the Upper Fastening Strips; Fig. 112: Fitting the Bottom Fastening Strip; Table 70: Tightening Torque (51007)

Operation Manual / A150-M56/66/57/67 - A155-M..
12 Dismantling and fitting, special tools for fastening strips / 12.1 Ap-
plication, special tools
© Copyright 2022 ABB. All rights reserved. HZTL4032_EN Rev.S February 2022
Fitting the fastening strips
Fig.111: Fitting the upper fastening strips
Product Size Tightening torque [Nm]
A150 M16 175
A155 M16 175
Table70: Tightening torque (51007)
1. Fit the nuts (51007) of the (upper) fastening strips (51002) illustrated and tighten with a
torque spanner(02) without a spanner holder. Observe the tightening torque.
Fig.112: Fitting the bottom fastening strip
2. Position the collection tub(01) to catch any fixing elements if they fall.
3. Tighten the two nuts on one side by using the spanner holder(90165).
4. Tighten the two nuts on the other side by using the spanner holder(90166).
The cartridge group is fitted at this point in time. To enable a clear representation of the
work step, the cartridge group is not illustrated in work step5.
Page 156 / 198