ABB IRB 6620 - Page 12

DescriptionRevision
This revision includes the following updates:
• A new block, about general illustrations, added in section How to read
the product manual on page 16.
• Robot designations are adjusted in sub-headings in section Robot
transportation precautions on page 48.
• Some general tightening torques have been changed/added, see up-
dated values in Screw joints on page 342.
• Added Safety risks during handling of batteries on page 36.
• The maximum allowed deviation in levelity of the base plate is changed,
see Securing the base plate on page 82.
• Added information about how to check oil level and change oil in the
axis-1 gearbox of a suspended robot, see Inspecting the oil level in
axis-1 gearbox on page 120 and Changing oil, axis-1 gearbox on page 151.
• Reference to Hilti standard added to the foundation recommendation
for the base plate and class designation for foundation is changed to
european standard C25/C30 (previously Swedish standard K25/K30),
see Securing the base plate on page 82.
• All data about type of lubrication in gearboxes is moved from the
manual to a separate lubrication manual, see Type and amount of oil
in gearboxes on page 149.
• Added section Inspection of air hoses (Foundry Prime) on page 148.
H
This revision includes the following updates:
• Corrected location of label for lifting, see Inspecting the information
labels on page 137.
• Spare part number for wrist (standard) was wrong. Has been corrected.
• A new SMB unit and battery is introduced, with longer battery lifetime.
J
This revision includes the following updates:
• New instruction for inspection of oil level.
• Added information about risks when scrapping a decommissioned robot,
see Scrapping of robot on page 337.
• Spare parts and exploded views are not included in this document but
delivered as a separate document. See Product manual, spare
parts - IRB 6620.
K
This revision includes the following updates:
• The maximum allowed deviation in levelness of the base plate and
foundation is changed, see Securing the base plate on page 82.
• Changed dimension of cable holder carrier screw, see Replacement of
cable harness, upper end on page 192.
• Added tightening torque for R1.SMB and 7th axis connector, ses Re-
placement of cable harness, lower end (axes 1-2) on page 185.
• Minor corrections.
L
This revision includes the following updates:
• Split fork lift accessory instruction in two sections.
• Improvements Foundry Plus (retrofit sets) added throughout the
manual. New wrist cover and improved sealing on arm house cover,
and more.
• Minor corrections.
M
This revision includes the following updates:
• Minor corrections.
N
Continues on next page
12 Product manual - IRB 6620
3HAC027151-001 Revision: T
© Copyright 2006-2018 ABB. All rights reserved.
Overview of this manual
Continued