NoteAction
xx1000001080
Refit the support washers on the outside of
the upper link arm, on the lock nuts.
9
For art. no. see:
• Required equipment on page 222
Apply locking liquid on the threads of the
lock nuts.
10
For art. no. see:
• Required equipment on page 222
Tightening torque: 120 Nm.
xx1000001080
Refit the support washer and lock nuts
complete securing the upper link arm at both
ends of the link arm. Use a KM10 socket
11
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section DANGER
- First test run may cause injury or damage!
on page 45.
12
3HAC039838-001 Revision: C 227
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.4.4 Replacing linkage - upper link arm
Continued
To Next Page
Loading...
