NoteAction
xx1000001111
Refit the plastic screws in the M12 hole of the
balancing device.
16
xx1000001101
Remove the lock screw.17
DANGER
Make sure all safety requirements are met when
performing the first test run. These are further
detailed in the section DANGER - First test run
may cause injury or damage! on page 45.
18
3HAC039838-001 Revision: C 273
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.5.1 Replacing the balancing device
Continued
To Next Page
Loading...
