NoteAction
Secure the balancing weight with round-
slings (using the lifting lugs) in an overhead
crane or similar.
3
xx1000001300
Lift the balancing weight and put it in its
position on the parallel arm.
4
For art. no. see:
• Required equipment
Attachment screws: M16x120 (2 pcs)
Put locking liquid (Loctite 243) on the attach-
ment screws.
5
Tightening torque:
• 165 Nm.
xx1000001296
Secure the balancing weight with its attach-
ment screws and washers.
6
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section DANGER
- First test run may cause injury or damage!
on page 45.
7
3HAC039838-001 Revision: C 277
© Copyright 2013 ABB. All rights reserved.
4 Repair
4.5.2 Replacing the balancing weight
Continued
To Next Page
Loading...
