Lifting robot with fork lift
This section details how to secure the fork lift set to the robot in order to lift and
move the robot using the fork lift ONLY!
NoteAction
If a cooling fan for the axis 1 motor is used, it
must be removed in order to use the fork lift
device!
Release the brakes if required as de-
tailed in section Manually releasing the
brakes on page 73.
xx1000001093
Position the robot as shown in the figure to the
right!
1
Attachment points are shown in figure
Attachment points on robot on page 62.
Fit the two adapters to the robot and secure.2
Attachment screws, 2 pcs, M16 x 90.
Tightening torque: 270 Nm.
Continues on next page
64 3HAC039838-001 Revision: C
© Copyright 2013 ABB. All rights reserved.
2 Installation and commissioning
2.3.1 Lifting robot with fork lift
Continued
To Next Page
Loading...
