2 Installation
2.1.2. Connections on the control module
3HAC021272-001 Revision: H20
© Copyright 2004-2008 ABB. All rights reserved.
Safety signal connections
The safety signal cable from a drive unit is connected to the Panel board according to the
following figure:
xx0400001295
Remove the jumper connector and replace it with the safety signal cable.
X7 Connector for safety signal cable to drive module #1(already connected at delivery)
X8 Connector for safety signal cable to drive module #2
X14 Connector for safety signal cable to drive module #3
X17 Connector for safety signal cable to drive module #4
Continued
To Next Page
Loading...
