2 Installation
2.1.3. Connections on the drive module
213HAC021272-001 Revision: H
© Copyright 2004-2008 ABB. All rights reserved.
2.1.3. Connections on the drive module
Already connected at delivery
When a MultiMove system is delivered from ABB, the Ethernet cable and the safety signal
cable are already connected to the drive module. You only need to know how these cables are
connected if you ar going to change the hardware configuration or replace parts.
Connect the cables from the control module
xx0400001000
Connect the Ethernet cable to the Ethernet connection marked Computer module link.
Connect the safety signal cable according to Safety signal connection on page 22.
A Ethernet connection
B Contactor interface board
A
B
Continues on next page
To Next Page
Loading...
