ABB OmniCore V400XT - Maintenance; Maintenance Schedule for the OmniCore Controller

4 Maintenance
4.1 Maintenance schedule for the OmniCore controller
General
The controller must be maintained at regular intervals to ensure its function. The
activities and intervals are described in this section.
Activities and intervals
Detailed in section:IntervalMaintenance
activity
Equipment
Inspecting the OmniCore V400XT
controller on page 160
12 months
i
InspectionComplete controller
Cleaning air filter on page 161CleaningAir filter
Replacement of air filter on page 16724 monthsReplacementAir filter
Inspecting the OmniCore V400XT
controller on page 160
6 months
i
InspectionSystem fans
Cleaning of the controller cabinet
on page 164
CleaningControl cabinet
Cleaning the FlexPendant on
page 165
When neededCleaningFlexPendant
Function test of emergency stop on
page 171
12 monthsFunction testEmergency stop
(FlexPendant)
Function test of manual, auto, and
manual full speed mode with Flex-
Pendant on page 172
12 monthsFunction testManual, auto and
manual full speed
mode with FlexPend-
ant
Function test of three-position en-
abling device on page 173
12 monthsFunction testEnabling device
Function test of Automatic Stop on
page 175
12 monthsFunction testAuto stop (tested if
used)
Function test of General Stop on
page 176
12 monthsFunction testGeneral stop (tested
if used)
Function test of external emergency
stop on page 177
12 monthsFunction testExternal emergency
stop (tested if used)
Function test of ESTOP_STATUS
output on page 178
12 monthsFunction testESTOP_STATUS
output (tested if
used)
Function test of reduced speed
control on page 179.
During commis-
sioning
Function testReduced speed
control
i
The interval depends on the working environment of the equipment: a cleaner environment may
extend the maintenance interval and vice versa.
Function test after replacement of component
After replacing a component in the controller, the function tests should be
performed. See Function tests on page 171.
Product manual - OmniCore V400XT 159
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
4 Maintenance
4.1 Maintenance schedule for the OmniCore controller