ABB OmniCore V400XT - Replacing the Power Supply

5.2.12 Replacing the power supply
Location
The illustration shows the location of the power supply in the controller.
xx2300001798
WARNING
Do not touch the power supply when the DC OK LED is on.
There is residual voltage in the power supply even if the main switch is in the
OFF position.
Continues on next page
Product manual - OmniCore V400XT 251
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.12 Replacing the power supply