7.2 Troubleshooting fault symptoms
Fault symptoms described in this manual
This manual describes how to troubleshoot the following fault symptoms:
• No LEDs are lit on the controller on page 346
• Start-up failure on page 349
• Problem releasing the robot brakes on page 353
• Problem starting or connecting the FlexPendant on page 356
• Problem using the joystick on page 360
• Controller fails to start on page 361
• Reflashing firmware failure on page 362
• Inconsistent path accuracy on page 363
• Controller is overheated on page 365
Continues on next page
Product manual - OmniCore V400XT 345
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
7 Troubleshooting
7.2 Troubleshooting fault symptoms
To Next Page
Loading...
