ABB OmniCore V400XT User Manual

5.2.18 Replacing the break resistor bleeder
Location
The illustration shows the location of the break resistor bleeder in the controller.
xx2200001072
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore V400XT via myABB Business Portal,
www.abb.com/myABB.
Continues on next page
Product manual - OmniCore V400XT 281
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.18 Replacing the break resistor bleeder

ABB OmniCore V400XT Specifications

General

Model	OmniCore V400XT
Compatibility	ABB Robots
Programming Language	RAPID
User Interface	FlexPendant
Mounting	Floor, Wall, Ceiling
Frequency	50/60 Hz
I/O Options	Digital, Analog, Fieldbus
Communication Protocols	EtherNet/IP, PROFINET, TCP/IP
Operating Temperature	0 to 45 °C
Humidity	5% to 95% non-condensing
Noise Level	<70 dB
Type	Industrial Robot Controller