NoteArticle numberSpare part
3HAC081951-001Break resistor bleeder assembly
Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 424.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC082020-008Circuit diagram - OmniCore
V400XT
Removing the break resistor bleeder
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 29.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 45.
2
xx2300001842
Removing the rear cover on page 184.Remove the rear cover of the controller.3
Opening the door on page 182.Open the door.4
Removing the break resistor bleeder
Note/IllustrationAction
Remove the cable ties.1
Continues on next page
282 Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.18 Replacing the break resistor bleeder
Continued
To Next Page
Loading...
