Note/IllustrationAction
Screws: Torx pan head screw M4x8 (4 pcs)Position the power unit on the lower
guiding pin on the mounting plate, and
then tip the unit upwards against the up-
per guiding pin. Secure the screws.
3
Tightening torque: 2 Nm
xx2300001492
Reconnect any connectors disconnected
at removal.
4
Concluding procedure
Note/IllustrationAction
Closing the door on page 183.Close the door.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 171.
2
250 Product manual - OmniCore V400XT
3HAC081697-001 Revision: A
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.2.11 Replacing the HVLP power unit (DSQC3072)
Continued
To Next Page
Loading...
