10 Upon Reception Manual Power Quality Filter PQFM
Figure 1: Lifting a single PQF cubicle by using the lifting lugs
For multiple cubicles mounted on a base frame, lifting rods (not provided) should be
used.
Figure 2: Lifting a PQF cubicle assembly by using lifting rods
PQFM-cubicles must always be transported vertically.
Plate versions (IP00) of filters may be lifted horizontally or vertically. This is done by
attaching lifting hooks to the holes provided at the top and bottom left and right corners
of the IP00 plate.
Table 1: Maximum allowed ambient conditions during transportation
Transportation (in the protected package)
Contamination levels (IEC 60721-3-3)
Mechanical class 3S3
(b)
To Next Page
Loading...