12
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
4 Transport and storage
Risk of injury due to device slipping.
The device's center of gravity may be higher than the
harness suspension points.
• Make sure that the device does not slip or turn during
transport.
• Support the device laterally during transport.
WARNING
Potential damage to the device!
The protection plates or protection caps mounted at the
process connections on devices with PTFE / PFA liners
may only be removed immediately before installation.
• To prevent possible leakage, make sure that the liner
on the flange is not cut or damaged.
NOTICE
Inspection
Check the devices immediately after unpacking for possible
damage that may have occurred from improper transport.
Details of any damage that has occurred in transit must be
recorded on the transport documents.
All claims for damages must be submitted to the shipper
without delay and before installation.
Transport
• Use carrying straps to transport flange designs smaller
than 18” (DN 450).
• Wrap the carrying straps around both process
connections when lifting the device.
• Chains should not be used, since these may damage the
housing.
Life-threatening danger due to suspended loads.
In the case of suspended loads, a danger of the load falling
exists.
• Standing under suspended loads is prohibited.
DANGER
Figure 6
G12034
To Next Page
Loading...
Need help?
General
