4
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
General information and instructions
These instructions are an important part of the product and
must be retained for future reference.
Installation, commissioning, and maintenance of the product
may only be performed by trained specialist personnel who
have been authorized by the plant operator accordingly. The
specialist personnel must have read and understood the
manual and must comply with its instructions.
For additional information or if specific problems occur that
are not discussed in these instructions, contact the
manufacturer. The content of these instructions is neither
part of nor an amendment to any previous or existing
agreement, promise or legal relationship.
Modifications and repairs to the product may only be
performed if expressly permitted by these instructions.
Information and symbols on the product must be observed.
These may not be removed and must be fully legible at all
times. The operating company must strictly observe the
applicable national regulations relating to the installation,
function testing, repair and maintenance of electrical
products.
Warnings
The warnings in these instructions are structured as follows:
1 Safety
The signal word ‘DANGER’ indicates an imminent danger.
Failure to observe this information will result in death or
severe injury.
The signal word ‘WARNING’ indicates an imminent danger.
Failure to observe this information may result in death or
severe injury.
WARNING
DANGER
The signal word ‘CAUTION’ indicates an imminent danger.
Failure to observe this information may result in minor or
moderate injury.
The signal word ‘NOTICE’ indicates possible material
damage.
CAUT ION
NOTICE
Note
‘Note’ indicates useful or important information about the
product.
To Next Page
Loading...
Need help?
General
