FEP630, FEH630 ELECTROMAGNETIC FLOWMETER | OI/FEP630/FEH630-EN REV. D 93
Menu / parameter Description
Input/Output / ...Dig.Out V1/V2 / ...Setup Logic Output
Input/Output / ...Dig. Out V3/V4 / ...Setup Logic Output
Logic Output Action Selection of binary output function.
See description ‘„Input/Output / ...Dig.Out 41/42 / ...Setup Logic Output’.
Active Mode Select switching properties for the binary output.
• Active High: Normally open
• Active Low: Normally closed
Default setting: Active High.
Input/Output / ...Dig.Out V1/V2 / ...Alarm Config
Input/Output / ...Dig. Out V3/V4 / ...Alarm Config
General Alarm Select error messages signaled via the binary output V1 / V2 or V3 / V4.
Only if the parameter ‘Logic Output Action’ is set to Alarm Signal.
Qv Volumeflow Max
Qv Volumeflow Min
EPD
TFE
Gas Bubble
Conductivity
Sensor Temperature
In house Temp
Input/Output / ...Dig.In V1/V2
Input/Output / ...Dig.In V3/V4
Function Select a function for the digital input.
• No function: No function.
• Reset all Totalizer: Counter reset for all counters (forward flow, reverse flow and difference totalizer)
• Stop all Totalizer: External counter stop for all counters (forward flow, reverse flow and difference totalizer)
• Auto. Zero Adjust: Start external zero point balancing.
• Set Flowrate to zero: Sets flow measurement to 0.
• Start/Stop Batching: Start / stop fill operation (only when FillMass function is activated).
• Dual Range Mass: Switchover Qm Max 1 / Qm Max 2.
• Dual Range Volume: Switchover Qv Max 1 / Qv Max 2.
Active Mode Select switching properties for the digital input.
Delay Time Selection of delay time for suppressing EMC faults on the digital input.
To Next Page
Loading...
Need help?
General
