The contents of the buffer can be read using the L command, 5 events at a time.
Using the L command erases the previously read events from the buffer, with the
exception of events E50 and E51 which have to be reset by using the C command. If
a fault occurs and reading fails for example in data communication, the events can
be re-read by using the B command. If needed, the B command can also be repeated.
Events to be included in the event reporting are marked with the multiplier 1. The
event mask is formed by the sum of the weighting factors of all those events which
are to be included in event reporting.
Table 5.1.17.1.-1 Event masks
Event mask Code Setting range Default setting
V155 E31...E36 0...63 1
1V155 1E1...1E12 0...4095 1365
1V156 1E13...1E24 0...4095 1365
1V157 1E25...1E42 0...262143 4180
2V155 2E1...2E16 0...65535 3
2V156 2E17...2E26 0...1023 0
3V155 3E1...3E12 0...4095 1023
3V156 3E13...3E22 0...1023 1008
Channel 0
Events always included in the event reporting:
Table 5.1.17.1.-2 Event codes E1...E4 and E7
Channel Event Description
0 E1 IRF
0 E2 IRF disappeared
0 E3 Warning
0 E4 Warning disappeared
0 E7 The thermal level has been changed via serial communication
Table 5.1.17.1.-3 Event codes E50...E51
Channel Event Description
0 E50 Relay restart
0 E51 Event buffer overflow
Events possible to mask out:
Table 5.1.17.1.-4 Event codes E31...E36
Channel Event Description Weighting
factor
Default
value
0 E31 Disturbance recorder triggered 1 1
0 E32 Disturbance recorder memory cleared 2 0
0 E33 HMI Setting password opened 4 0
0 E34 HMI Setting password closed 8 0
0 E35 HMI Communication password opened 16 0
132
REF610REF610
Feeder Protection Relay
Technical Reference Manual - ANSI Version
1MRS755535
To Next Page
Loading...
