ABB REL650 - Event Counter CNTGGIO

Table 22: Settings for calibration parameters
Setting Short Description Selected
value
Comments
IMagComp5 Magnitude factor to calibrate
current at 5% of In
0.00
IMagComp30 Magnitude factor to calibrate
current at 30% of In
0.00
IMagComp100 Magnitude factor to calibrate
current at 100% of In
0.00
VAmpComp5 Magnitude factor to calibrate
voltage at 5% of Vn
0.00
VMagComp30 Magnitude factor to calibrate
voltage at 30% of Vn
0.00
VMagComp100 Magnitude factor to calibrate
voltage at 100% of Vn
0.00
IAngComp5 Angle calibration for current at 5%
of In
0.00
IAngComp30 Angle pre-calibration for current
at 30% of In
0.00
IAngComp100 Angle pre-calibration for current
at 100% of In
0.00
14.5 Event counter CNTGGIO
14.5.1 Identification
Function description
IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Event counter CNTGGIO
S00946 V1 EN
-
14.5.2 Application
Event counter (CNTGGIO) has six counters which are used for storing the number of
times each counter has been activated. CNTGGIO can be used to count how many times
a specific function, for example the tripping logic, has issued a trip signal. All six counters
have a common blocking and resetting feature.
14.5.3 Setting guidelines
Operation: Sets the operation of Event counter (CNTGGIO) Enabled or Disabled.
1MRK 506 334-UUS A Section 14
Monitoring
437
Application manual