M2697-2 v2
Always use a conductive wrist strap connected to protective ground when replacing
modules. Electrostatic discharge (ESD) may damage the module and IED circuitry.
M2698-2 v2
Take care to avoid electrical shock during installation and commissioning.
M2693-2 v2
Changing the active setting group will inevitably change the IED's operation. Be careful
and check regulations before making the change.
2.4 Note signs
IP1497-1 v1
M19-2 v3
Observe the maximum allowed continuous current for the different current transformer
inputs of the IED. See technical data.
1MRK 504 165-UUS Rev. J Section 2
Safety information
Transformer protection RET670 27
Commissioning manual
© 2017 - 2021 Hitachi Power Grids. All rights reserved
To Next Page
Loading...
