IEC 61850 or function
name
ANSI Function description Transformer
RET670
(Customized)
ZCLCPSCH Local acceleration logic 0-1
ECPSCH 85 Scheme communication logic for residual overcurrent protection 0-1
ECRWPSCH 85 Current reversal and weak-end infeed logic for residual overcurrent protection 0-1
Table 8: Number of function instances in Synchrophasor report, 24 phasors
Function name Function description Total number of
instances
PMUCONF Configuration parameters for IEC/IEEE 60255-118 (C37.118) 2011 and
IEEE1344 protocol
1
PMUREPORT Protocol reporting via IEEE 1344 and IEC/IEEE 60255-118 (C37.118) 1
PHASORREPORT1 Protocol reporting of phasor data via IEEE 1344 and IEC/IEEE 60255-118
(C37.118), phasors 1-8
1
PHASORREPORT2 Protocol reporting of phasor data via IEEE 1344 and IEC/IEEE 60255-118
(C37.1
18), phasors 9-16
1
PHASORREPORT3 Protocol reporting of phasor data via IEEE 1344 and IEC/IEEE 60255-118
(C37.1
18), phasors 17-24
1
ANALOGREPORT1 Protocol reporting of analog data via IEEE 1344 and IEC/IEEE 60255-118
(C37.1
18), analogs 1-8
1
BINARYREPORT1 Protocol reporting of binary data via IEEE 1344 and IEC/IEEE 60255-118
(C37.1
18), binary 1-8
1
SMAI1–SMAI12 Signal Matrix for analog inputs 1
3PHSUM Summation block 3 phase 6
PMUSTATUS Diagnostics for IEC/IEEE 60255-118 (C37.118) 2011 and IEEE1344 protocol 1
3.5 Basic IED functions
GUID-C8F0E5D2-E305-4184-9627-F6B5864216CA v14
T
able 9: Basic IED functions
IEC 61850 or function
name
Description
INTERRSIG
SELFSUPEVLST
Self supervision with internal event list
TIMESYNCHGEN Time synchronization module
BININPUT,
SYNCHCAN,
SYNCHGPS,
SYNCHCMPPS,
SYNCHLON,
SYNCHPPH,
SYNCHPPS, SNTP
,
TIMEZONE
Time synchronization
DSTBEGIN GPS time synchronization module
Table continues on next page
1MRK 504 165-UUS Rev. J Section 3
A
vailable functions
Transformer protection RET670 41
Commissioning manual
© 2017 - 2021 Hitachi Power Grids. All rights reserved