Table of contents
Section 1 Introduction.......................................................................................................15
1.1 This manual...............................................................................................................................15
1.2 Intended audience.....................................................................................................................15
1.3 Product documentation............................................................................................................. 16
1.3.1 Product documentation set......................................................................................................16
1.3.2 Document revision history.......................................................................................................17
1.3.3 Related documents................................................................................................................. 18
1.4 Document symbols and conventions.........................................................................................18
1.4.1 Symbols...................................................................................................................................18
1.4.2 Document conventions............................................................................................................19
1.5 IEC 61850 edition 1 / edition 2 mapping................................................................................... 20
Section 2 Safety information............................................................................................ 25
2.1 Symbols on the product.............................................................................................................25
2.2 Warnings................................................................................................................................... 25
2.3 Caution signs.............................................................................................................................26
2.4 Note signs................................................................................................................................. 27
Section 3 Available functions........................................................................................... 29
3.1 Main protection functions.......................................................................................................... 29
3.2 Back-up protection functions..................................................................................................... 30
3.3 Control and monitoring functions...............................................................................................32
3.4 Communication......................................................................................................................... 38
3.5 Basic IED functions................................................................................................................... 41
Section 4 Starting up.........................................................................................................45
4.1 Factory and site acceptance testing..........................................................................................45
4.2 Commissioning checklist........................................................................................................... 45
4.3 Checking the power supply....................................................................................................... 46
4.4 Energizing the IED.................................................................................................................... 46
4.4.1 Checking the IED operation.................................................................................................... 46
4.4.2 IED start-up sequence ............................................................................................................46
4.5 Setting up communication between PCM600 and the IED....................................................... 47
4.6 Writing an application configuration to the IED..........................................................................52
4.7 Checking CT circuits................................................................................................................. 52
4.8 Checking VT circuits..................................................................................................................53
4.9 Using the RTXP test switch ......................................................................................................53
4.10 Checking the binary input/output circuits...................................................................................54
4.10.1 Binary input circuits................................................................................................................. 54
1MRK 504 165-UUS Rev. J Table of contents
Transformer protection RET670 1
Commissioning manual
© 2017 - 2021 Hitachi Power Grids. All rights reserved
To Next Page
Loading...
