- 14 -UMC22-FBP
Universal Motor Controller UMC22-FBP
Software version 4.0
FieldBusPlug / Issue: 02.2008
V 6
3.1.2 Step 2: Interfacing to the fi eldbus (continued)
Parametrization as a fi eldbus slave (3.3.3)
Situation: The control systems, programming tools and the fi eldbus types are totally different.
This means: There is no common rule to confi gure the fi eldbus master and to bind in FieldBusPlug
slaves into the application program.
Procedure:
Load the actual slave confi guration fi le into the programming tool of the bus master in the control
system. Examples:
ABB_082D.GSD for PROFIBUS DP-V1
ABB_UMC22.EDS for DeviceNet.
Create fi eldbus confi guration together with the application program in the control system.
For some control systems dedicated function blocks or example programs are available.
Depending on the control system and the fi eldbus type the ordering of the I/O signals can be made
automatically, otherwise "manual" ordering is necessary.
Depending on the control system and the fi eldbus type there are different possibilities to change
parameters:
- during confi guring or
- as a part of the control system program or
- with the Control Panel ACS100-PAN. As a special feature the Control Panel allows to read out
the complete parameter set of an UMC22 and to transfer it to another UMC22 (8.2.3).
Depending on the parameter the set parameter values are taken over at different instants, e.g after
switching off and on the UMC22 or the motor (4.3.2).
If a UMC22 is set into operation again after power off, it will start with the parameter values last
stored.
Further info
Switch on and off motor (3.4)
Signalling (3.7)
Info available on the LEDs (3.7.1)
Control Panel, Info and Local control (password protected) (8.1.1 ff.)
Replace an UMC22-FBP or the controller unit only (3.8)
Chapter 3.1.2~2
To Next Page
Loading...
