ABB UMC22-FBP - Page 162

- 162 -UMC22-FBP
Universal Motor Controller UMC22-FBP
Software version 4.0
FieldBusPlug / Issue: 02.2008
V 6
Par.
No.
Menu
No.
Menu point name Display:
7-segm.
Default Range Description / remark take over
- 3.14
Parameter
transfer
(4.3.4)
All parameter information - exept
the Slave address, Operation hours,
Number of starts and Number of trips
- can be read out from or write into the
UMC22.
power up
transition
3.14.1 Read parameters
Control Panel reads out all parameter
information from an UMC22.
3.14.2 Set parameters
Control Panel overwrites all parameter
information in the UMC22.
- 3.15
Reset to Default
(4.3.4)
power up
transition
3.15.1 execute
Sets all parameter values to default
values exept the parameters Address,
Number of starts, Number of trips and
Operating hours.