ABB UMC22-FBP - Page 46

- 46 -UMC22-FBP
Universal Motor Controller UMC22-FBP
Software version 4.0
FieldBusPlug / Issue: 02.2008
V 6
Parameter group: Overload protection
 Trip class
 Phase loss protection
 Cooling time
 Automatic fault reset
 Start-up time *
 Blocking current threshold *
 Low current threshold *
 High current threshold *
Parameter group: Communication
 Bus fault reaction
 Address check *
Parameter group: Sercive info
No parameter, only additional information, control system can only read them, change only by Control Panel
 Self test
 Operating hours
 Number of starts
 Number of trips
Parameter group: Other info
These parameters are only accessible via Control Panel
 Address
The fi eldbus address can be changed also with the separate Addressing Set CAS21-FBP.0.
 Password panel control (8.1.4 and 8.2.2)
Switch on and off motor. Dominating against control system, but needs password.
 Password
Password needed for entering Menu level 2 and 3 of Control Panel.
 Change password
Change password for entering Menu level 2 and 3 of Control Panel.
 Bus connection
Can be set to Off when UMC22 is used stand alone without connection to a control system.
 Parameter lock
Blocks the change of the parameters -
mainly used for use of the motor in potential explosive atmospheres.
 Parameter transfer
Transfer (read/write) of the complete parameter set from one UMC22 to one or more other
UMC22.
 Reset to default
Reset all values to default, except the values of the parameters Address, Operating hours, Num-
ber of starts and Number of trips.
* These parameters can only be changed by the control system, not with the Control Panel.
Chapter 4.3.1~2
4.3.1 Parameter groups (continued)