- 48 -UMC22-FBP
Universal Motor Controller UMC22-FBP
Software version 4.0
FieldBusPlug / Issue: 02.2008
V 6
Chapter 4.3.2~2
4.3.2 Single Parameter Transfer using the numeros of the Parameters (continued)
Para
No.
Qty.
Byte
Parameter name Defi nition / Range Default value
(text version)
Default
(digital)
take-over
after
1)
22 1 Local control Off (0), On (1), 002 (2), 003 (3),
004 (4), 005 (5), 006 (6) , 007 (7) ,
008 (8) , 009 (9)
Off 0 motor off
23 1 Blocking current
threshold
0 - 800 % * Set current,
step: 5 %
800 % 160 motor off
24 1 Fault output Off (0), On (1),
blink (3)
Off 0 motor off
25 1 Number of trips 0 - 255,
step: 1
0 0 (read only)
26 1 Address check Off (0),
On (1)
Off 0 power up
1)
: but only when the internal fault bit is not set.
To Next Page
Loading...
