- 66 -UMC22-FBP
Universal Motor Controller UMC22-FBP
Software version 4.0
FieldBusPlug / Issue: 02.2008
V 6
Parameter
name /
Parameter
number
Remark
Parameter value
Description of parameter values
Control
system
(digital
value if
different)
Control
Panel
Set current 1
01
Accessible via control system or Control Panel (menu point: Cur1)!
Attention!
If the parameter Current factor shall be higher than 100% - referring to 1.00 - it should be sent
before ore together with the changed Set current.
The UMC22 divides the Set current by the Current factor. When the RUN signal appears and the
result is higher than 63 A the RUN signal will be ignored and the internal fault signal will be set
(parameter out of range).
24-6300 00.24-
63.00
0.24-63 A (step: 0.01 A): 0.24 A = 0.01 A x 24
at current factor = 1 (default)
42-109 00.42-
109.0
0.42-109 A (step: 0.01 A): 0.42 A = 0.01 A x 42
at current factor = 1.73 (for 冑3 circuits)
5000-32000 0050-
3200
1-3200 A (step: 0.01 A): 50 A = 0.01 A x 500
at current factor > 10 (for circuits with external current transformers with
secundary currents of approx. 5 A)
Set current 2
03
Accessible via control system or Control Panel (menu point: Cur2)!
Remark:
Only for Pole-changing and (two-pole Dahlander) starter!
24-6300 00.24-
63.00
0.24-63 A (step: 0.01 A): 0.24 A = 0.01 A x 24
at current factor = 1 (default)
42-10900 00.42-
109.0
0.42-109 A (step: 0.01 A): 0.42 A = 0.01 A x 42
at current factor = 1.73 (for 冑3 circuits)
5000-320000 0050-
3200
1-3200 A (step: 0.01 A): 50 A = 0.01 A x 500
at current factor > 10 (for circuits with external current transformers with
secundary currents of approx 5 A)
Chapter 4.3.4~16
4.3.4 Parameter - Details in alphabetical order (continued)
To Next Page
Loading...
