Acea RTCA SP Instrument - Page 2

Acea RTCA SP Instrument

60 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Table of Contents

Default Chapter3
- Table of Contents3
- Prologue5
Revision History5
Contact Addresses5
Declaration of Conformity6
Warranty6
Trademarks6
Intended Use6
- III. Declaration of Conformity6
License Statements for the Instrument7
- VIII. Software License Agreement7
VIII. Software License Agreement7
Preamble7
Use of the Instrument Operator's Manual8
Conventions Used in this Manual8
Warnings and Precautions10
- XIII. Disposal of the Instrument12
A Overview13
- Overview13
Introduction13
- RTCA SP Instrument14
Speciﬁ Cations of the Instrument17
- Speciﬁ Cations of the RTCA Analyzer17
- Speciﬁ Cations of the RTCA SP Station17
- Speciﬁ Cations of the RTCA Control Unit17
- Speciﬁ Cations of the E-Plate 9618
- Speciﬁ Cations of the RTCA Resistor Plate 9618
B System Description19
System Package19
System Description20
- Description of the RTCA Analyzer21
- Description of the RTCA SP Station22
  - Cradle Pocket and Clamp Plate23
  - RTCA Protector Shield 96 and RTCA Contact Pins 9623
- RTCA Control Unit24
- E-Plate 96 and RTCA Resistor Plate 9625
- RTCA Frame 9626
- RTCA Software27
- RTCA Cleaning and Replacement Equipment27
Installation28
- Installation Warnings28
- Unpacking28
- Space and Power Requirements29
- Environmental Requirements29
- Installation of the RTCA SP Instrument29
- Resistor Plate Veriﬁ Cation of the RTCA SP Instrument31
C Operation35
Introduction35
Instrument Start-Up and Warm-Up35
Preparing and Starting a Run on the RTCA SP Instrument36
- Running a Quick Experiment36
- Important Tips for Using the RTCA SP Instrument42
D Maintenance and Care44
General Maintenance44
Cleaning Instructions45
- General Cleaning45
- Further Recommendations45
Cleaning and Exchanging the RTCA Contact Pins 9646
Exchanging Fuses50
E Appendix52
Troubleshooting52
- I Started an Experiment and There was an Error Message, "Cannot Fi Nd Instrument", What Happened52
- I Started an Experiment and There was a Sound and Error Message, "No Station", What Happened53
- I Started an Experiment. There was an Error Message, "ACK Communication Lost." What Happened54
- How Do I Reinitialize the RTCA SP Instrument after a Power Failure55
- The Cell Index Signal Is Signiﬁ Cantly Lower than Usual. Why55
- The Cell Index Signal Decreases with Time, but There was no Compound Added. Why56
- The Cell Index Signal Is Signiﬁ Cantly Higher than Usual. Why56
- I DID a Background Measurement. the RTCA Software Indicated that Many Wells May Have Background Problems. What Should I Do57
  - The Device Indicating LED DID Not Turn Green. What Should I Do58
- I am Contacting the Local ACEA Representative or ACEA Technical Support58
  - What Data Fi Les Should be Sent58
  - I Placed an E-Plate 96 into the Cradle of the RTCA SP Station the Device Indicating LED DID Not Turn Green. What Should I Do58
Ordering Information59

Related product manuals