Machine Maintenance Procedures 3-35
ODD Connector Removal 0
Prerequisite:
Mainboard Cover Removal
1. Locate ODD connector (A) on front cover. (Figure 3-35)
Figure 3-35. ODD Connector
2. Peel ODD mylar (C) from front cover.
3. Remove WLAN mylar (D) from front cover.
4. Disconnect ODD cable (G) from mainboard connector (H).
5. Remove WLAN main (E) and auxiliary (F) cables from guides on front cover.
6. Remove ODD cable from guides.
7. Remove screws (B) from front cover.
8. Remove ODD connector.
ODD Connector Installation 0
1. Install ODD connector (A) to front cover. (Figure 3-35)
2. Install and secure screws (B) to front cover.
3. Secure ODD cable (G) to guides on front cover.
4. Secure WLAN main (E) and auxiliary (F) cables to guide.
5. Connect ODD cable (G) to mainboard connector (H).
6. Install WLAN mylar (D) to front cover.
7. Install ODD mylar (C) to front cover.
8. Install mainboard cover.
ID Size Quantity Screw Type
B M2.0x6.0 2
To Next Page
Loading...
