Machine Maintenance Procedures 3-27
HDD Module Installation 0
1. Install HDD module into slots (J) on front cover. (Figure 3-26)
Figure 3-26. Slots on Front Cover
2. Align ground cable (C) to screw hole on HDD module. (Figure 3-25)
3. Install and secure screw (B) to ground cable and HDD module.
4. Secure HDD cables (D) and (G) to guides (H) on front cover.
5. Connect the following cables:
HDD cable (D) to mainboard connector (E)
HDD cable (G) to mainboard connector (F)
6. Install rear cover.
ID Size Quantity Screw Type
B M3.0x4.0 1
To Next Page
Loading...
