Machine Maintenance Procedures 3-25
Infrared Board Removal 0
Prerequisite:
Rear Cover Removal
1. Locate infrared board (A) on front cover. (Figure 3-24)
Figure 3-24. Infrared Board
2. Disconnect infrared board cable (C) from board connector (D).
3. Remove screw (B) from infrared board.
4. Remove infrared board from guide pin (E) on front cover.
Infrared Board Installation 0
1. Align and install infrared board (A) with guidepin (E) on front cover. (Figure 3-24)
2. Install and secure screw (B) to front cover.
3. Connect infrared board cable (C) to board connector (D).
4. Install rear cover.
ID Size Quantity Screw Type
B M2.0x3.0 1
To Next Page
Loading...
