Machine Maintenance Procedures 3-17
ODD Module Installation 0
1. Install ODD bracket (K) to ODD module. (Figure 3-15)
2. Install and secure screws (J) from ODD bracket to ODD module.
3. Install ODD bezel (H) to ODD tray (F). (Figure 3-14)
4. Install and secure latch (G) to tray.
5. Install ODD tray (F) into ODD module.
6. Install ODD module (A) in ODD slot (C) on rear cover. (Figure 3-12)
7. Install and secure screw (B) to lower cover.
8. Install rear cover.
ID Size Quantity Screw Type
B M3.0x4.0 1
J M2.0x3.0 2
To Next Page
Loading...
