Acer Aspire Z3801 - Converter Board Removal; Converter Board Installation

Machine Maintenance Procedures 3-23
Converter Board Removal 0
Prerequisite:
Rear Cover Removal
1. Locate converter board (A) on front cover. (Figure 3-22)
Figure 3-22. Inverter Board
2. Disconnect the following cables:
Converter to mainboard cable (B) from converter board connector (C)
Converter to panel cable (F) from converter board connector (E)
3. Remove screws (D) from front cover.
4. Remove converter board.
Converter Board Installation 0
1. Install converter board (A) to front cover. (Figure 3-22)
2. Install and secure screws (D) to front cover.
3. Connect the following cable:
Converter to panel cable (F) to converter board connector (E)
Converter to mainboard cable (B) to inverter board connector (C)
4. Install rear cover.
ID Size Quantity Screw Type
D M3.0x4.0 2
A
B
C
D
D
E
F