Acer Aspire Z3801 - DOS Flash Utility

2-16 System Utilities
DOS Flash Utility 0
To use the DOS Flash Utility, perform the following:
1. Press F12 during boot to enter Setup Menu.
2. Select Boot Options to modify boot priority order.
3. Move Removal Device to 1st Boot Device position (Figure 2-15). (Refer to Boot Options
menu)
Figure 2-15. Change BIOS Boot priority Order
4. Copy the BIOS file to USB HDD.
5. Insert the USB HDD and reboot computer to DOS mode.
NOTE:
NOTE:
Two DOS batch files are included to flash system BIOS:
FBB.BAT only updates system BIOS
FBBME.BAT updates system BIOS and Intel ME firmware.
BIOS Setup Utility
Main
Advanced
Power
Security
Boot Options Exit
Boot Priority Order Set Boot Priority
1st Boot Device
[Removable Device]
2nd Boot Device
[Hard Disk: ST31000..]
3rd Boot Device
[CD&DVD: HL-DT-ST..]
4th Boot Device [UEFI]
5th Boot Device
[LAN]
UEFI Boot Device Priority
Hard Disk Drive Priority
Optical Disk Drive Priority
Removal Device Priority
Network Device Priority
Quite Boot
[Press Enter]
[Press Enter]
[Press Enter]
[Press Enter]
[Press Enter]
[Enabled]
Select Screen
Select Item
Enter: |Select
+/-: 11||Change Opt.
F7: Load User-defined Defaults
F8: Save as User-defined
F9: Optimized Defaults
(When Access Level is
Administrator)
F10: Save & Exit
Halt On
[All, but Keyboard]
Version 2.10.1208. Copyright (C) 2002-2011, Acer Inc.