3-22 Machine Maintenance Procedures
Power Board Removal 0
Prerequisite:
Rear Cover Removal
1. Locate power board (C) on front cover. (Figure 3-21)
Figure 3-21. Power Board
2. Disconnect power board cable (A) from power board connector (B).
3. Remove screw (D) from front cover.
4. Remove power board from guide pin (E) on front cover.
Power Board Installation 0
1. Align and install power board (C) with guide pin (E) on front cover. (Figure 3-21)
2. Install and secure screw (D) to front cover.
3. Connect power board cable (A) to power board connector (B).
4. Install rear cover.
ID Size Quantity Screw Type
D M3.0x4.0 1
To Next Page
Loading...
