3-24 Machine Maintenance Procedures
LED Switch Board Removal 0
Prerequisite:
Rear Cover Removal
1. Locate LED switch board (A) on front cover. (Figure 3-23)
Figure 3-23. LED Switch Board
2. Disconnect LED switch board cable (B) from connector (C).
3. Remove screw (E) from board.
4. Remove LED switch board from guide pin (D) on front cover.
LED Switch Board Installation 0
1. Align and install LED switch board (A) with guide pin (D) on front cover. (Figure 3-23)
2. Install and secure screw (E) to board.
3. Connect LED switch board cable (B) to connector (C).
4. Install rear cover.
ID Size Quantity Screw Type
E M3.0x4.0 1
To Next Page
Loading...
