ACS Tech80 SB1391 - Page 13

XII TABLES
SB1391 Hardware and Setup Guide - Document revision no. 1.14
TABLE 4-19 Encoder 2 connection pins ...................................................................................4-24
TABLE 4-20 Digital input/output supply selection ...................................................................4-25
TABLE 4-21 Input/output connection pins................................................................................ 4-26
TABLE 4-22 HSSI + PEG connection pins............................................................................... 4-31
TABLE 4-23 Indicator LEDs..................................................................................................... 4-33
TABLE 4-24 DIP switches ........................................................................................................4-34
TABLE 4-25 Current test points ................................................................................................4-35
TABLE 5-1 Topics covered in this chapter..................................................................................5-1
TABLE 5-2 Resources for more information about topics covered in this chapter.....................5-3
TABLE 5-3 ACS Tools................................................................................................................5-4
TABLE 5-4 Adjustment steps......................................................................................................5-5
TABLE 5-5 Amplifier record fields........................................................................................... 5-14
TABLE 5-6 Motor record fields.................................................................................................5-19
TABLE 5-7 Detailed guidelines for calculating protective parameters .....................................5-28
TABLE 5-8 Two ways to read and set an ACSPL parameter....................................................5-46
TABLE 6-1 Topics covered in this chapter..................................................................................6-1
TABLE 6-2 D and K arrays .........................................................................................................6-2
TABLE 6-3 Removing and restoring Z and K array protection................................................... 6-3
TABLE 6-4 Displaying and setting values of D array elements..................................................6-4
TABLE 6-5 Displaying and setting values of K array elements.................................................. 6-4
TABLE 7-1 Topics covered in this chapter..................................................................................7-1
TABLE 7-2 Changing the baud rate.............................................................................................7-2
TABLE 7-3 CAN rotary switch positions and associated modes ................................................7-6
TABLE 7-4 Predefined motion state functions for digital outputs ............................................7-11
TABLE 7-5 Outputs commands.................................................................................................7-11
TABLE 7-6 MN (Monitor)parameter.........................................................................................7-12
TABLE 7-7 DC (Data Collection) parameter bit assignment ....................................................7-12
TABLE 7-8 Scale factor as a function of MF ............................................................................7-13