ACS Tech80 SB1391 - Page 8

FIGURES VII
SB1391 Hardware and Setup Guide - Document revision no. 1.14
FIGURES
FIGURE 2-1 Cable Spacing......................................................................................................... 2-4
FIGURE 2-2 Shielded Cable........................................................................................................ 2-4
FIGURE 2-3 Improved Shielding ................................................................................................ 2-5
FIGURE 2-4 Case shielding (top of control module) .................................................................. 2-5
FIGURE 4-1 SB1391 mounting dimensions................................................................................ 4-2
FIGURE 4-2 Wiring diagram....................................................................................................... 4-4
FIGURE 4-3 Wire stripping dimension for terminal block connections ..................................... 4-5
FIGURE 4-4 Power supplies and suggested use of line filter...................................................... 4-6
FIGURE 4-5 Electrical schematic of 12A, and 16A line filter for single-phase.......................... 4-8
FIGURE 4-6 Electrical schematic of 25A line filter for single-phase ......................................... 4-8
FIGURE 4-7 Electrical schematic of 6A line filter for three-phase............................................. 4-8
FIGURE 4-8 Electrical schematic of 12A and 16A line filter for three-phase ............................ 4-9
FIGURE 4-9 Jumper JP2 (factory default: installed) on driver board ......................................... 4-9
FIGURE 4-10 Three-phase motor connection ........................................................................... 4-11
FIGURE 4-11 Single-phase (DC brush) motor connection ....................................................... 4-12
FIGURE 4-12 Regeneration resistor - external and internal...................................................... 4-13
FIGURE 4-13 RS-232 connection ............................................................................................. 4-15
FIGURE 4-14 RS-422/485 connection ...................................................................................... 4-16
FIGURE 4-15 CAN bus............................................................................................................. 4-17
FIGURE 4-16 Encoder interface................................................................................................ 4-19
FIGURE 4-17 Hall sensors connection...................................................................................... 4-20