ACS Tech80 SB1391 - Page 9

VIII FIGURES
SB1391 Hardware and Setup Guide - Document revision no. 1.14
FIGURE 4-18 Internal 5Vdc supply connection for encoder and Hall......................................4-21
FIGURE 4-19 External 5Vdc supply connection for encoder and Hall.....................................4-21
FIGURE 4-20 Resolver connection ..........................................................................................4-23
FIGURE 4-21 Switch connection for temperature protection....................................................4-23
FIGURE 4-22 Jumpers for selecting I/O supply source and for selecting input type ................4-25
FIGURE 4-23 Jumper 12 for digital input-type selection..........................................................4-28
FIGURE 4-24 Input port interface .............................................................................................4-29
FIGURE 4-25 Output port interface...........................................................................................4-30
FIGURE 4-26 Joystick connection ...........................................................................................4-30
FIGURE 4-27 PEG outputs and corresponding digital outputs ................................................. 4-32
FIGURE 4-28 The 7-segment display........................................................................................4-33
FIGURE 4-29 DIP switches (off)...............................................................................................4-34
FIGURE 4-30 Location of current test points............................................................................4-34
FIGURE 5-1 Working with the controller ...................................................................................5-2
FIGURE 5-2 Adjustment procedure ............................................................................................5-6
FIGURE 5-3 Adjuster status bar ..................................................................................................5-8
FIGURE 5-4 "Communication error" message............................................................................5-9
FIGURE 5-5 Communications settings........................................................................................ 5-9
FIGURE 5-6 Choose version dialog box ...................................................................................5-10
FIGURE 5-7 Add amplifier command.......................................................................................5-11
FIGURE 5-8 "Create a new amplifier database" message .........................................................5-12
FIGURE 5-9 Add new amplifier item dialog box......................................................................5-12
FIGURE 5-10 Opening the amplifier list...................................................................................5-13
FIGURE 5-11 Amplifier specification (varies by type).............................................................5-14
FIGURE 5-12 Add motor command..........................................................................................5-16
FIGURE 5-13 "Create a new motor database" message ............................................................5-16
FIGURE 5-14 Add new motor item dialog box.........................................................................5-17
FIGURE 5-15 New motor record dialog box.............................................................................5-17
FIGURE 5-16 Motor type list ....................................................................................................5-18
FIGURE 5-17 Motor specification (varies by type)...................................................................5-18
FIGURE 5-18 Starting adjustment session ................................................................................5-21
FIGURE 5-19 Control unit warning before adjustment session ................................................5-22
FIGURE 5-20 Adjustment steps ................................................................................................5-22
FIGURE 5-21 Amplifier parameters step ..................................................................................5-23
FIGURE 5-22 Selecting the amplifier type................................................................................5-24