ECD-1000 Product Manual
18
Connecting the Cameras
The Decoder can decode up to 16 IP cameras or video encoders and display the videos
through an HDMI (1080p) or composite monitor or display remotely via PC or a mobile client.
To connect a camera, do the following:
1. Connect the camera to a PoE switch, within in the same network segment as the Decoder,
using an Ethernet cable.
2. Configure the IP address of the camera, if necessary (please refer to the camera hardware
manual on how to do this).
3. Once ready, access the Decoder user interface to search and finalize the camera
connection (see Quick Setup on page 23).
To Next Page
Loading...
