ECD-1000 Product Manual
20
1.4 Device Maintenance
This section describes how to reset the device and switch between NTSC and PAL system.
Resetting the Device
In case there is a need to reset the device to its default factory settings, perform the following:
1. With the device powered off, press and hold the Reset button with a pointed object (e.g.
pen).
2. Power on the Decoder, either by connecting the power adaptor or connecting the Decoder
to a PoE switch.
3. Continue to press the Reset button for 5 seconds or when the Factory Default LED lights
green. The Factory Default LED indicates resetting has started. The Factory Default
LED lights on and off several times until it completely lights up to indicate reset is
complete.
Switching Between NTSC and PAL Mode
When the Decoder is powered on, briefly press the NTSC and PAL switch (also the Reset
button) to switch between NTSC and PAL mode.
To Next Page
Loading...