5
O. Model Selection – The Phase 7 dual microprocessor controller (DMC) computer can be programmed to be
used on six (6) different model dryers, defined by heat type and the quantity of motors.
P. Keyboard (Touch Pad) Symbols – = “PAUSE/CLEAR” key
= “MED/ENTER” key
= “HI/UP” key (scroll up)
= “LO/DOWN” key (scroll down)
Q. Currency Symbol – The Phase 7 DMC (computer) can be programmed to display ALL currency in one (1)
of the following currency symbols, a token mode, none, and no symbol or decimal point.
USD / UK Pound / EURO / Yen / Token / None / No Symbol or Decimal
R. Dry Mode – The Phase 7 DMC (computer) can be programmed to operate in either Coin Mode or Free Dry
Mode.
S. Vending Safeguard – This feature provides protection against counterfeit coins.
T. Credit Retention – In the event that the Phase 7 DMC (computer) experiences a power loss, the Phase 7
DMC (computer) will automatically retain the amount of remaining credit that a customer had at the time of
the power loss. When power is restored, the Phase 7 DMC (computer) will prompt the user to select a
temperature cycle, and will vend the appropriate amount of time according to the amount of remaining credit
that was present at the time of the power loss.
U. Time for Amount to Start – Allows each temperature setting to vend its own amount of time for the
amount of credit inserted to start a cycle.
V. Time for Top Off – Allows each temperature setting to vend its own amount of additional time for the
amount of credit inserted for additional time.
W. Ready Prompt – This setting allows the user to remove the AMOUNT TO START from the “READY
INSERT $XX.XX TO START” message so that the Phase 7 DMC (computer) will display “READY”. This
feature is useful for dryers that are equipped with debit card readers that display their own AMOUNT TO
START.
X. Scrolling Rate – When in a menu item that has a numeric range, this feature will vary the scroll rate as you
scroll through the numeric range to help decrease the programming time.
To Next Page
Loading...