34 American Dryer Corp. 112144-46
I. PREPARATION FOR OPERATION
The following items should be checked before attempting to operate the dryer:
1. Read ALL “CAUTION,” “WARNING,” and “DIRECTION” labels attached to the dryer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the dryer data label located on the
inside of the middle access (control) door.
3. GAS MODELS - check to assure that the dryer is connected to the type of heat/gas indicated on the dryer data
label.
4. GAS AND ELECTRIC MODELS - the sail switch damper assembly was installed and adjusted at the factory
prior to shipping. However, each sail switch adjustment must be checked to assure that this important safety
control is functioning.
5. Check bolts, nuts, screws, terminals, and fittings for tightness.
6. GAS MODELS - be sure that ALL gas shutoff valves are in the open position.
7. Be sure ALL back guard panels and service box covers have been replaced.
8. Check the lint door to assure that it is closed and secured in place.
9. Rotate the basket (tumbler) by hand to be sure they move freely.
10. STEAM MODELS - check to insure that the air supply (80 PSI [5.51 bar]) is on the dryer.
11. For more effective automatic door closure and better tumbling action (and improved efficiency), the dryer
should be tilted slightly to the rear.
J. PREOPERATIONAL TEST
ALL dryers are thoroughly tested and inspected before leaving the factory. However, a preoperational test should
be performed before the dryer is publicly used. It is possible that adjustments have changed in transit. Installer must
instruct the user on how to correctly operate the dryer before leaving.
1. Turn on electric power to the dryer.
a. Open ALL gas or steam shutoff valves (for gas and steam models only)
2. Dual Microprocessor Controller (DMC) Computer System Operational Test
a. Coin Models Only
1) The light emitting diode (L.E.D.) display(s) will flash back and forth between “FILL” and the amount
needed to start the dryer (i.e., “25”), meaning that the dryer is available and 25¢ is required to start it.
2) Insert the proper number of coins into coin acceptor. Once the correct amount needed to start the dryer
has been inserted, the L.E.D. display(s) will read “PUSH”...“tEnP.”
To Next Page
Loading...
Need help?
General
