12
To see the error fault, press “LO” , and the fault will be displayed. Refer to Section VIII for a complete list of
faults and descriptions.
If the dryer is paused, the Phase 7 dual microprocessor controller (DMC) computer will display:
CYCLE PAUSED...
B. FREE MODE
If Phase 7 DMC (computer) is in Free Mode and is in a READY state, the Phase 7 DMC (computer) will display:
SELECT TEMP TO START
Likewise, if the dryer is equipped with a Sensor Activated Fire Extinguishing (S.A.F.E.) system and there is an
issue with the system, the Phase 7 DMC (computer) will display:
S.A.F.E. SYSTEM DISABLED...SELECT TEMP TO START
If a malfunction is detected in Free Mode, the fault will be displayed. Refer to Section VIII for a complete list
of faults and descriptions.
If the dryer is paused, the Phase 7 DMC (computer) will display:
CYCLE PAUSED…SELECT TEMP TO RESTART OR PAUSE TO CLEAR CYCLE
C. MESSAGES COMMON TO COIN AND FREE MODES
Once a dry cycle has been selected, regardless of Coin or Free Mode, the Phase 7 DMC (computer) will toggle
between the following two (2) messages:
One (1) of the following messages, depending on the cycle selected:
LOW DRY TEMPERATURE
HIGH DRY TEMPERATURE
MEDIUM TEMPERATURE
And one (1) of the following messages, depending on time remaining:
XX:XX MINUTES REMAINING
00:XX SECONDS REMAINING
If the door is opened, the Phase 7 DMC (computer) will display:
MAIN DOOR OPEN
If the main door is open, and a dry cycle is selected, the Phase 7 DMC (computer) will display:
CLOSE MAIN DOOR
To Next Page
Loading...
Need help?
General
